Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Albuquerque, NM

Opener Gear & Sprocket Replacement in Albuquerque, NM

Stripped drive gears replaced so the motor moves the door again. Typical cost $125-$275.

Our opener gear & sprocket replacement service in Albuquerque, NM comes down to three things: a clear diagnosis, the right parts on the truck, and a door that is balanced and safety-tested when we finish. Stripped drive gears replaced so the motor moves the door again.

Is it time for opener gear & sprocket replacement?

  • The motor hums or runs but the chain or belt doesn't move
  • Grinding from inside the opener
  • Plastic shavings under the motor

Why this happens

  • A heavy, out-of-balance door wearing the gear
  • Age and wear on the nylon gear

What you can check yourself

  • Check the door's balance first. A heavy door will strip a new gear too.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

Our opener gear & sprocket replacement process

  1. Check the door's balance and springs
  2. Open the motor head and replace the gear and sprocket
  3. Grease the new gear
  4. Re-set the limits and force
  5. Test it through several cycles

Opener Gear & Sprocket Replacement cost in Albuquerque, NM

$125-$275Typical range, parts & labor
about 1 hourTypical time on site

What moves the price:

  • Drive type: chain, belt, screw or wall-mount
  • Whether the fix is a part or a whole new opener
  • Remotes, keypads and smart accessories
  • Ceiling height and rail extensions

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Serving Albuquerque, NM and nearby towns

Summer garage temperatures in New Mexico are hard on opener motors and electronics, and dust in the rail or screw drive adds friction that makes the opener work harder.

Technicians serve all of Albuquerque (ZIP codes 87101, 87102, 87103, 87104, 87105 and more), plus Lee Acres (4.4 mi), South Valley (5.4 mi), Los Ranchos de Albuquerque (5.4 mi) and North Valley (6.3 mi). Call (833) 435-8883 to book a visit in Albuquerque.

Opener Gear & Sprocket Replacement: frequently asked questions

How much does opener gear & sprocket replacement cost in Albuquerque, NM?

Opener Gear & Sprocket Replacement typically costs $125-$275 including parts and labor, and usually takes about 1 hour. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do opener gear & sprocket replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is opener gear & sprocket replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where New Mexico or Albuquerque requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my opener?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the opener is near the end of its life, replace it. Most openers last 10 to 15 years. If yours is older than that, lacks photo eyes or rolling-code security, or needs a logic board or motor, a new opener is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Albuquerque, NM

Overhead Door Extension Spring Replacement

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$350

High-Speed Door Repair

Fabric and rigid high-speed doors repaired and recalibrated.

Typical $400-$2,000

Overhead Door Rolling Steel Door Repair

Rolling steel service doors, curtains, guides and springs repaired.

Typical $300-$1,500

Skylink Remote & Keypad Programming

Skylink makes openers and a wide range of universal replacement remotes and keypads.

Typical $50-$150

Overhead Door Garage Door Track Repair

Overhead Door traces its roots to C.G. Johnson, who invented the upward-acting garage door in 1921. The company builds residential and commercial doors and openers.

Typical $150-$400

Haas Door Garage Door Roller Replacement

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $150-$350

Garaga Extension Spring Replacement

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $150-$350

Sommer Remote & Keypad Programming

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $50-$150

Northwest Door Torsion Spring Replacement

Torsion springs replaced and wound correctly, with high-cycle upgrades available.

Typical $200-$450

Glass & Aluminum Garage Doors

Modern full-view aluminum doors with tempered or insulated glass.

Typical $3,000-$10,000

Garaga Garage Door Installation

Garaga is a Canadian garage door manufacturer based in Quebec.

Typical $1,200-$4,500

Raynor Weather Seal Replacement

Raynor, based in Dixon, Illinois, makes residential and commercial garage doors as well as openers.

Typical $100-$300

Garage door stuck, noisy or broken?

Talk to a garage door technician in Albuquerque, NM now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote